Visualize and plan where you want to hang the poster. Have a friend or family member hold it up so you can see what it looks like. Try a few different walls — your poster may look better on a wall opposite or adjacent to the window for better light. Clean the area where you’re hanging your poster. A microfiber cloth works well for this.
Poster hangers are wood or plastic clips that go on the top and sometimes the bottom of your poster. Poster hangers are magnetized or glued to sandwich the poster in between. Typically a nail is used to hang these as shown in the example above. Poster hangers give you a cost-effective, attractive solution if you don’t want a bare poster.
Hammer/nails- If you’re hanging a framed poster, using poster hangers or any other hammer and nail method—because using the bottom of your shoe to hammer in a nail is much harder. Stud Finder-This handy tool eliminates guesswork so you’re putting your nail in the stud the first time.
Attach two 3M Spring Clips to the top of your poster about one inch from each side. Peel the protective strip off the back of the clip. Stick the clips to the wall just below the blue tape line. If the bottom of the poster lifts, add two more clips to the bottom edge. This is for hanging multiple pictures or posters at once.
0:443:51How to Hang a Poster Without Damaging the Wall - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd then all you need to do is stick it in all four corners of your poster to hang the poster i likeMoreAnd then all you need to do is stick it in all four corners of your poster to hang the poster i like to start in the left hand corner. Press that down. And pull with your right hand.
Washi tape and mounting sticky putty are the best options for hanging posters, according to Herrero. However, these methods will only work with lightweight artwork printed on paper. For the best results, the surface and poster must be flat and clean.
Some ways you can hang them are with thumb tacks or staples, poster mounting tack, poster tapes, or mounting it to a backing if you don't mind causing damage to the poster. Magic and washi tapes, Velcro fasteners, and even magnets to hold up your artwork can be used when you want to preserve the quality of your poster.
If your picture frame has a hook on the back, you can also use adhesive hooks. Adhesive hooks have a weight rating of between one and eight pounds. You can use multiple hooks to hold artwork that weighs more than eight pounds. Like adhesive strips, these can be easily removed from smooth wall surfaces without damage.
Command Poster Strips let you hang posters, kid's artwork, banners, and signs without the hassle of tools and nails. Command Strips hold strongly on a variety of smooth, finished surfaces, and these adhesive strips remove cleanly with no sticky residue or damage left behind.
For the most part, double-sided tape shouldn't cause any damage to your walls. Considering that double-sided tape is typically clear, this means you won't have to deal with residue or marks left behind, which is perfect for those renting.
Scotch® Removable Poster Tape is a unique double-coated mounting tape that securely mounts posters and lightweight objects on wood walls or doors, tile, glass, refrigerators, vinyl wallpaper, primed and painted walls. Scotch® Removable Poster Tape is ideal for lightweight mounting like papers, photos, cards and more.
Product Description. Great for temporary mounting of paper items such as posters, charts and decorations, Duck Brand Poster Putty is removable and reusable. It is a safe, clean alternative to tape, nails, glues, tacks and staples won't damage mounting surface and will not dry out.
9 creative and affordable ideas to hang a posterLook for solutions at thrift stores, estate sales, garage sales. ... Mount your poster on blank canvas. ... Make a poster collage wall. ... Create your own custom frame with decorative molding. ... For small poster hanging, try pant hangers. ... Swiss poster clips and foam board.More items...•
When used correctly, most mounting tape poses a minimal risk of damaging your walls. Check out different available tapes, as some tape may be stronger than others and have a maximum hold. However, patience should be exercised when removing mounting tape.
How to Hang Things without Damaging Your WallsUse hooks with special adhesive. ... Fine some unique decorative tape. ... Hang your art on clothespins. ... Use putty to hang up your favorite works of art. ... Use a wire display. ... Use decals as decorations. ... Use magnetic paint. ... Heers Management.
0:234:42How I put my posters up without damaging them - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce your posters are ready you basically just need to unfold them in their way and just put themMoreOnce your posters are ready you basically just need to unfold them in their way and just put them backwards. Then you can use this type of transparent tape.
There are products out there especially for helping you learn how to hang posters so there’s no damage. A mounting putty is an excellent option in comparison to tacks or nails. Putty allows you to pinch off the size you need and it great for lightweight posters that need to be removed easily.
The first tip is to wash your hands first before you take your poster out of the protective shipping tube .#N#This will ensure your poster is free of cheese puff crumbs, grease or any kinds of lotion or body butter that could be on your hands. If you want to be really bougie, you can get white cotton photography gloves to handle your posters. These are also great for handling fine art too.
Posters are fun! And they're great for art, and also advertising. There is a plethora of poster printing for anything you can imagine as well!
Mounting tape is for more substantial pieces. If you don’t want to use nails or tacks, this is a good option. It’s good for objects weighing several pounds. It’s a bit much for a regular poster but will work in a pinch. However, don’t expect it to release easily if you want to remove it.
You could use duct tape. But that’s a super bad idea because duct tape can get too stuck to your poster and damage your wall! Nobody wants ripped posters and paint being peeled off either. Or you could use staples, nails or tacks.
Quick tip: When you do remove your poster, do it slowly and peel from the edges. If you need to have a little extra umph if you concerned about an old or fragile poster you can use a hair dryer or heat gun to release any old adhesive.
Coffee table books work great for this. When you order prints on gatorboard or gallery wrapped canvas, you won’t have to flatten them out. However, it’s always a good idea to flatten out paper posters.
You can hang them from lines, hooks, and screws, against or away from walls. This approach might look sloppy and isn’t really recommended in all situations. The clips may also create indentations on your posters, though using bulldog clips instead of the more common standard binder clips, can help you avoid this problem a bit.
2.) Magic tape. If you don’t have access to double-sided adhesive, Magic tape will do in a pinch. Unlike regular scotch tape, Magic tape is not as “tacky” and will easily detach from your posters, even after months or years of use, depending on the climate.
Choosing the wrong kind of poster tape can result in a gunked-up wall or a poster that tears apart when you remove it. 2.) Magic tape. wikipedia.org/wiki/Magic_Tape.
Clean hands make for less residue when you remove the poster from the tube.
This might sound like a dumb way to hang posters, but toothpaste – not to be confused with tooth gel – can be used to safely attach posters to most surfaces for a few days. The cheaper the better. Don’t use anything with additional additives or whiteners as this makes for poorer adhesion.
As strange as it seems, not everyone is aware that there really are products specifically designed to help you mount posters without marking or damaging either the poster or the surface you need to mount it on. Just be sure that you use the correct kind of tape and that all surfaces are clean. Choosing the wrong kind of poster tape can result in a gunked-up wall or a poster that tears apart when you remove it.
The better the quality of the poster, the better they will hold up to a variety of mounting tools. Make sure you print high quality posters to keep yours looking their best.
Pull down slightly on the corners of the poster and stick it to the wall one corner at a time, avoiding any ripples or creases in the poster.
Stick a piece of blue painter’s tape to the wall to mark where the top of your poster will be. Level the tape with a bubble level.
Stick a piece of blue painter’s tape to the wall to mark where the top of your poster will be. Level the tape with a bubble level. Place your poster face down on a clean flat surface. Peel the protective strip off and stick them in each corner of the back of your poster.
Place your poster face down on a clean flat surface. Stick the putty balls in each corner of the back of your poster. First, stick the left corner to the wall just below the blue tape line. Then, while still holding a poster, stick the right corner .
Hold your poster over the paper clips and place the magnets on the front of your poster, magnetically attaching to the paper clips.
Before taping the paper clips to the wall, make sure the surface is smooth, clean, and dry and the paint is fully cured.
Stick the clips to the wall just below the blue tape line.
Command Strips. Command strips come in lots of shapes and sizes and are probably the most common way to hang a poster. Command strips can be ordered as an accessory with our custom posters or at any other hardware or big-box retailer type store. They are also easy to find on Amazon.
If you have a framed poster or plan on framing it or you’re using a poster hanger, here are a few handy things to have on hand that will make the hanging process lots easier: 1 Tape Measure- Eyeballing is great, but sometimes you need to measure to make sure things are centered or in the correct placement. 2 Pencil- Making a tiny mark on your wall with a pencil will make it so much easier to know where to place your nail. Pencil washes off easily. 3 Level- A small level will ensure your poster isn’t hung wonky. 4 Hammer/nails- If you’re hanging a framed poster, using poster hangers or any other hammer and nail method—because using the bottom of your shoe to hammer in a nail is much harder. 5 Stud Finder- This handy tool eliminates guesswork so you’re putting your nail in the stud the first time.
Washing your hands helps to make sure you don’t get smudges or fingerprints on your poster . Cardstock is a little more common for ad and event posters and fingerprints aren’t as noticeable, but clean hands are especially important for glossy or photo quality posters.
Simply take a small bead of putty and warm it in your fingers until it is soft and pliable, stick it to your poster, then onto your clean wall. For an average size poster, one dot in each corner plus a few more in the middle should be fine. For larger posters, put extra dots of putty along the edges.
Velcro, sometimes called hook and loop, is a good option for larger or heavier posters (such as ones made from cardstock). Another peel and stick option that, depending on the brand and features, doesn’t damage your walls. Because velcro tabs are meant for a little bit heavier duty items, they’re not quite as flat as something like double-sided poster tape. You can find velcro tabs at most stores by the command strips, as well as online. We provide a set of 6 2” x 2” velcro tabs as an optional accessory with our custom posters.
Let your poster “cure” or sit for a while to straighten out and keep from rolling. A thicker poster may need to cure longer (12 to 24 hours) than light or thin paper posters.
Use a heat gun or blow dryer when removal becomes difficult. Often a little bit of heat can loosen adhesive just enough to help you remove your poster without damaging it or the wall. The best part about posters is that, for the most part, they’re a budget-friendly way to dress up your room, home, office or business.